Main (barcode/command/name) mode

About the mode

If this mode is set when scanning/adding a code in the main field, the following actions are completed:

(1) Look for a product related to the particular code. If there is only one product which meets the conditions =>(4)

(2) Open a dropdown list in the field Product containing the products filtered by the scanned code. The system recommends the user to choose a product. Once a specific product is selected => (4)

(3) STOP

(4) A specific product has been selected. Check whether the product uses lots. If yes =>(8)

(5) Check whether the product uses serial numbers. If yes => (10)

(6) The product does not use lots or serial numbers. Add the record to the form:

A new line using current values of the fields in the panel is created (for example 'Quantity = 5', 'Product = XXX').

Note

When adding a new product line, the panel is cleared and ready to be used again. The mode is 'Main'.

(7) STOP

(8) Turn on Lot number mode.

(9) STOP

(10) Switch to the last chosen mode for serial numbers. If not (it is the first use of the panel after the opening of the form) – the mode is chosen according to the following algorithm:

(11) If the type of the current form = ‘Receive’, the enabled mode will be the mode selected in the field Default mode for serial numbers input in the Barcode panel settings. ** (12) If the type of the current form = ‘Issue’ or ‘Indefinite’, the enabled mode will be Serial number.

(13) STOP